HP 5000 manual Move the Drop Detector, Following Service Calibration

Removal and Installation

1

6.Remove the T-15 screw (Type F) that attaches the Drop Detector Assembly to the Service Station.

7.Remove the Drop Detector from the Service Station.

NOTE	Move the Drop Detector
2	towards	the front of	the
	Service	Station until	the

locating pin reaches the end.

Pin

8.Lift the Foam from the Service Station.

NOTE The Foam may be full of ink so be careful when handling it.

NOTE If you replace the Drop Detector you must perform

the following Service Calibration:

ν Service Station ⇒ Page 5-11.

HP DesignJet 5000 Series Printers Service Manual 8-71