HP 5000 manual Scan-Axis Motor

Removal and Installation

Scan-Axis Motor

Removal

WARNING

NOTE

Switch off the Printer and remove the Power Cord.

Refer to the table on Page 8-4for information on screw types.

1.Remove the Right Rear Cover - Refer to Page 8-16.

2.Remove the Left Hand Cover - Refer to Page 8-6.

3.Remove the Right Hand Cover - Refer to Page 8-10.

4.Remove the 5.5 mm nut from the left hand side of the Printer that attaches the Encoder Strip to the Spring Clip.

TIP The next step is performed by putting pressure on the Spring Clip as shown.

5. Release the Encoder strip from the

1. Apply Pressure

Spring Clip.

2. Release Encoder Strip

HP DesignJet 5000 Series Printers Service Manual 8-55