HP 5000 manual Electronics Module as one complete Assembly

Removal and Installation

Electronics Module (as one complete Assembly)

Removal

WARNING

NOTE

Switch off the Printer and remove the Power Cord.

Refer to the table on Page 8-4for information on screw types.

1.Remove the Left Rear Cover - Refer to Page 8-15.

2.Remove the Right Rear Cover - Refer to Page 8-16.

3.Disconnect ALL Cables from the Main PCA (Right Rear Cover) and ISS PCA (Left Rear Cover) and remove the Ferrites from the left side.

4.Remove 2 T-15 screws (Type B) from

the both sides of the Electronics Module.

LEFT

RIGHT

1

1

5.Lift the Electronics Module up (to clear it from the shoulder screws) and remove from the Printer.

2

8-92 HP DesignJet 5000 Series Printers Service Manual