HP 5000 manual Accuracy Calibration, Codes for its description and resolution

Service Calibrations

3. Accuracy Calibration

NOTE

The purpose of this Accuracy Calibration is to set the nominal advance of the media, changing the factory default values stored on the EEROM. This calibration is necessary to control the exact movement of the media in order to avoid print quality problems like banding.

This changes the factory default value for the nominal advance of the media.

Perform the Service Accuracy Calibration whenever:

νPaper-axis Assembly is disassembled or replaced.

NOTE	If you get an error code, refer to Page 5-26, Calibration Error
	Codes for its description and resolution.
	Perform the Accuracy Calibration as follows:
	Make sure you load HP High Gloss Photo Paper into the Printer
WARNING
	before performing this calibration. Do NOT use any other type
	of media apart from HP High Gloss Photo Paper.

1.In the Service Calibrations submenu, select "2.3 Accuracy" and press Enter.

2 Service Calibrations...

2.1Scan axis

2.2Service Station

2.3ACCURACY

Top
Back
↑	Make Selection
↓
		Press Enter
Enter

2.When the following message appears on the front panel, select "Create Pattern" and press Enter.

2.3 ACCURACY

Create Pattern

Measure Pattern

Top
Back
↑	Make Selection
↓
		Press Enter
Enter

5-14 HP DesignJet 5000 Series Printers Service Manual