HP 510 Inkjet Large Format CH336A#B1K manual Safety Precautions

Removal and Installation

Introduction

This chapter is a step by step guide to the removal and installation of the key components in the printer. You may find it useful to tick off the steps as they are performed. Use the illustration at each procedure to identify the parts referred to in the text.

The procedures appear in order of removal. So the whole machine can be stripped down by starting at the beginning of this chapter and working through the subsequent procedures.

NOTE	Before using this chapter to remove and install a new component,
	always make sure that you have performed the relevant service
	test from Chapter 4. If the test passes you will not need to replace
	the component.

Safety Precautions

Review WARNING and CAUTION symbols and instructions before you service the printer. Follow these warnings and cautions for your protection and to avoid damaging the printer.

WARNING	Serious shock hazard leading to death or injury may result if you
	do not take the following precautions:
	Ensure that the ac power outlet (mains) has a protective earth
	(ground) terminal.
	Switch the plotter off, and disconnect it from the power source
	prior to performing any maintenance.
	Prevent water or other liquids from running onto electrical
	components or circuits, or through openings in the module.

8-2 HP DesignJets 500, 510 and 800 Series Printers Service Manual