HP 510 Inkjet Large Format CH336A#B1K manual 8613, Carriage-Axis shutdown Firmware Error

System Error Codes

System Error:	86:13
Problem	Carriage-Axis shutdown (Firmware Error).
Description:

Corrective Action: Try the following:

„Switch the Printer Off and wait a few minutes. Switch the Printer On again and check if the Error Code has disappeared.

„If the Error Code reappears, check for a new Firmware release.

„If the new Firmware release does not solve the problem, or if new Firmware release was not available, contact the HP Response Center (or directly to the Division) supplying the following information:

–Model and Serial Number of the Printer.

–Firmware release of the Printer (use the Printer Information utility ⇒ Page 4-27).

–The complete Error Code information, including the linefeed where the error occurred (use the Error Log utility to obtain this information ⇒ Page 2-5).

System Error:	87:13
Problem	Unable to read the Carriage Encoder Sensor.
Description:
Corrective Action:	Try the following:
	„ Switch the Printer Off and wait a few minutes. Switch the Printer
	On again and check if the Error Code has disappeared.
	„ If the Error Code continues, replace the Carriage Assembly ⇒
	Page 8-78or the Encoder Strip ⇒ Page 8-76.
System Error:	93:10
Problem	Ink System startup failed (also see Page 1-8for more information).
Description:
Corrective Action:	Try the following:
	„ Check for a leak in the Printer. If a leak is evident (there is ink on
	Printer components), replace the Ink Supply Tubes ⇒ Page 8-60.
	„ Perform the Prime Tubes utility (Refer to Page 4-24) and check
	how long it takes to complete the procedure. If it takes too long to
	complete the procedure and there is no leak in the Printer, then
	replace the Ink Cartridges. If it takes a short time to complete the
	procedure, then replace the Ink Supply Tubes ⇒ Page 8-60.

HP DesignJets 500, 510 and 800 Series Printers Service Manual 2-19