HP CM1410 Load Tray 1 Type SIZE, Press OK to use available media, Mode, OK to start, To continue

Table 13-1Control-panel messages (continued)

Control panel message Description Recommended action

Load Tray 1 <TYPE> <SIZE>, Press OK to use available media

Device is processing a job, but no trays match.

Load paper in the correct orientation.

Touch the OK button to use existing tray settings.

Load Tray 1, <PLAIN> <SIZE> / Cleaning	Cleaning mode paper prompt.	Load a clean sheet of paper in the correct
mode, OK to start		orientation, then touch the OK button to begin
		the cleaning procedures.
Magenta Cartridge Low	The print cartridge is nearing the end of its	Printing can continue, but consider having a
	useful life.	replacement supply on hand.
Magenta in wrong position	The print cartridge is installed in the incorrect	Make sure that each print cartridge is
	slot.	installed in the correct slot. From front to
		back, the print cartridges are installed in this
		order: black, cyan, magenta, and yellow.
Magenta Very Low	The print cartridge is at the end of its useful	To ensure optimal print quality, HP
	life, and the At Very Low menu item in the	recommends replacing the print cartridge at
	System Setup menu is set to Continue.	this point. You can continue printing until you
		notice a decrease in print quality. Actual
		cartridge life may vary.
		Once an HP supply has reached “very low”,
		HP's premium Protection Warranty on that
		supply has ended. All print defects or
		cartridge failures incurred when an HP supply
		is used in continue at very low mode will not
		be considered to be defects in materials or
		workmanship in the supply under the HP Print
		Cartridge Warranty Statement.
Manual Duplex Load Tray 1, Press OK	Manual duplex mode.	Load paper in the correct orientation.
Manual feed <SIZE> <TYPE>, Press OK to	Print Manual Feed mode.	Load paper into Tray 1.
use available media
Memory is low Try again later	The product does not have enough memory	Wait until the current job is finished before
	to start a new job.	starting a new job.
		Turn the product off and then on to clear the
		memory.
Memory is low. Press OK.	The product memory has been almost	Touch the OK button to cancel the job.
	completely filled.	Break the job into smaller jobs that contain
		fewer pages.
		Turn the product off and then on to clear the
		memory.
Memory low Only 1 copy made. Press OK	The product does not have enough memory	Break the job into smaller jobs that contain
to continue.	to complete the collated copy job.	fewer pages.
		Turn the product off and then on to clear the
		memory.
Misprint, Press OK	Feed delay misprint.	Verify that paper is loaded in the input tray.
		Reload paper.

218 Chapter 13 Solve problems ENWW