Table
Description | Recommended action |
|
|
|
|
Processing... | The product is currently processing a job but | No action is necessary. |
| is not yet picking pages. When paper motion |
|
| begins, this message will be replaced by a |
|
| message that indicates which tray the job is |
|
| being printed from. |
|
|
|
|
Processing... | The product is processing a cleaning page. | No action is necessary. |
CLEANING PAGE |
|
|
|
|
|
Processing... copy <X> of <Y> | The product is currently processing or | No action is necessary. |
| printing collated copies. The message |
|
| indicates that copy X of Y total copies is |
|
| currently being processed. |
|
|
|
|
Processing... from tray <X> | The product is actively processing a job from | No action is necessary. |
| the designated tray. |
|
|
|
|
RAM DISK DEVICE FAILURE | The specified device has failed. | Press the OK button to clear. |
To clear press OK |
|
|
|
|
|
RAM DISK FILE OPERATION FAILED | A PJL file system command attempted to | Press the OK button to clear. |
To clear press OK | perform an illogical operation. |
|
|
| |
|
|
|
RAM DISK FILE SYSTEM IS FULL | A PJL file system command could not store | Press the OK button to clear. |
To clear press OK | something on the file system because the file |
|
system was full. |
| |
|
|
|
RAM DISK IS WRITE PROTECTED | The file system device is protected and no | Press the OK button to clear. |
To clear press OK | new files can be written to it. |
|
|
| |
|
|
|
RAM DISK NOT INITIALIZED | This | Use the HP Embedded Web Server or |
| initialized before use. | HP Web Jetadmin to initialize the component. |
|
|
|
Ready | The product is online and ready for data. No | No action is necessary. |
| status or product attendance messages are |
|
| pending at the display. |
|
|
|
|
Ready | The product is online and ready. | No action is necessary. |
IP ADDRESS |
|
|
|
|
|
Ready Diagnostics mode | The product is in Diagnostics mode. | To stop Diagnostic mode, press the Stop |
To exit press |
| button . |
|
| |
|
|
|
Receiving Upgrade | A firmware upgrade is in progress. | Do not turn the product off until the product |
|
| returns to Ready. |
|
|
|
Remove all print cartridges | The product is testing the transfer unit | To perform the test, remove all the print |
To exit press | assembly. | cartridges. To cancel the test, press the stop |
| button . | |
|
|
|
Remove at least one print cartridge | The product is testing the | To perform the test, remove at least one print |
To exit press | motor. | cartridge. To cancel the test, press the stop |
| button . | |
|
|
|
REMOVE CARTRIDGE LOCKS | At least one cartridge shipping lock was not | 1. Open the front door. |
| removed before you turned the product on. | 2. Remove cartridge locks. |
|
| |
|
|
|
ENWW | Interpret |