HP CP4025DN Laser CC490A manual 207

Table 10-1Control-panel messages (continued)

Description	Recommended action
INCOMPATIBLE FUSER	The incorrect fuser was installed.	CAUTION: The fuser can be hot while the
		product is in use. Wait for the fuser to cool
		before handling it.
		1.	Open the right door.
		2.	Remove the incompatible fuser.
		3.	Install the correct fuser.
		4.	Close the right door.
INCOMPATIBLE SUPPLIES	Print cartridges or other supply items are	Press the OK button to identify the
For status press OK	installed that were not designed for this	incompatible supplies. Install supplies that
	product. The product cannot print with these	are designed for this product.
	supplies installed.
INCOMPATIBLE TRANSFER UNIT	The incorrect transfer unit was installed.	1.	Open right door.
		2.	Remove the incompatible transfer unit.
		3.	Install the correct transfer unit.
		4.	Close the right door.
Incorrect	The PIN is incorrect.	Use the up arrow and down arrow
		buttons to enter the correct PIN.
Initializing	The product is starting.	No action is necessary. Please wait until the
		Ready message appears on the display.
Initializing permanent storage	Displayed when the product is turned on to	No action is necessary.
	show that permanent storage is being
	initialized.

INSTALL <COLOR> CARTRIDGE	The print cartridge has been removed or has
	been installed incorrectly.

Replace or reinstall the print cartridge correctly to continue printing. See Replace print cartridges on page 164.

INSTALL FUSER	The fuser has been removed or installed	CAUTION: The fuser can be hot while the
	incorrectly.	product is in use. Wait for the fuser to cool
		before handling it.
		1.	Open the right door.
		2.	Install or adjust the fuser.
		3.	Close the right door.
INSTALL SUPPLIES	More than one supply is missing or is installed	Press the OK button to identify which supplies
For status press OK	incorrectly.	need to be replaced. Press the OK button a
		second time for more information about the
		specific supply. Insert the supply item or
		make sure the installed supply item is fully
		seated.
INSTALL TRANSFER UNIT	The transfer unit has been removed or	1.	Open right door.
	installed incorrectly.	2.	Install the transfer unit.
		3.	Close the right door.
INSUFFICIENT MEMORY TO LOAD	The product does not have enough memory	To continue without this information, press
FONTSDATA	to load the data (for example, fonts or	the OK button . If the message persists, add
	macros) from the location specified.	more memory.

ENWW Interpret control-panel messages 193