Manually configure IPv4 TCP/IP parameters from the control panel
Use the
1.Press the Home button .
2.Open each of the following menus. Press the down arrow to highlight it and then press the OK button to select it.
a.CONFIGURE DEVICE
b.I/O
c.EMBEDDED JETDIRECT MENU
d.TCP/IP
e.IPV4 SETTINGS
f.CONFIG METHOD
g.MANUAL
h.MANUAL SETTINGS
i.IP ADDRESS, SUBNET MASK, or DEFAULT GATEWAY
3.Press the up arrow or the down arrow
to increase or decrease the number for the first byte of the IP address, subnet mask, or default gateway.
4.Press the OK button to move to the next set of numbers, or press the back arrow to move to the previous set of numbers.
5.Repeat steps 3 and 4 until the IP address, subnet mask, or default gateway is complete, and then press the OK button to save the setting.
6.Press the Home button to return to the Ready state.
ENWW | Connect to a network 75 |