HP CP4025DN Laser CC490A manual Link speed and duplex settings, Setting Description

Link speed and duplex settings

The link speed and communication mode of the print server must match the network. For most situations, leave the product in automatic mode. Incorrect changes to the link speed and duplex settings might prevent the product from communicating with other network devices. If you need to make changes, use the product control panel.

NOTE: Making changes to these settings causes the product to turn off and then on. Make changes only when the product is idle.

1.Press the Home button .

2.Open each of the following menus. Press the down arrow to highlight it and then press the OK button to select it.

a.CONFIGURE DEVICE

b.I/O

c.EMBEDDED JETDIRECT MENU

d.LINK SPEED

3.Press the down arrow to highlight one of the following options.

Setting	Description
AUTO	The print server automatically configures itself for the highest link speed and
	communication mode allowed on the network.
10T HALF	10 megabytes per second (Mbps), half-duplex operation
10T FULL	10 Mbps, full-duplex operation
100TX HALF	100	Mbps, half-duplex operation
100TX FULL	100	Mbps, full-duplex operation
100TX AUTO	Limits auto-negotiation to a maximum link speed of 100 Mbps
1000T FULL	1000 Mbps, full-duplex operation

4.Press the OK button. The product turns off and then on.

ENWW Connect to a network 77