HP CP4025DN Laser CC490A manual Replace Transfer KIT, ROM Disk Device Failure

Table 10-1Control-panel messages (continued)

Description Recommended action

REPLACE SUPPLY Printing black only

At least one print cartridge has reached the very low condition and you have set the COLOR CARTRIDGES items to the PRINT IN BLACK option.

The supply life remaining is used to determine if a supply is very low. The supply life remaining is an approximation only and varies depending on the types of documents printed and other factors.

No action is required for printing to continue in black. To continue printing in color, either replace the print cartridge or reconfigure the product by using the MANAGE SUPPLIES menu on the control panel.

For more information about ordering supplies, see Supplies and accessories on page 235.

For more information about the MANAGE SUPPLIES menu, see Manage supplies menu on page 16.

REPLACE TONER COLLECTION UNIT	The product indicates when a toner collection
	unit is at its estimated end of life. The actual
	life remaining might be different than the
	estimation. Have a replacement toner
	collection unit available to install when print
	quality is no longer acceptable. The toner
	collection unit does not need to be replaced
	now unless the print quality is no longer
	acceptable. After a toner collection unit has
	reached its approximated end of life, HP’s
	premium Protection Warranty on that toner
	collection unit ends.

Replace the toner collection unit.

If you wish to have the toner collection unit operate past its estimated capacity, configure the product to continue printing by using the MANAGE SUPPLIES menu. For more information about the MANAGE SUPPLIES menu, see Manage supplies menu

on page 16. This is not a recommended option because of the risk of overfilling the toner collection unit, which could result in the need to service the product.

REPLACE TRANSFER KIT	The product indicates when a transfer kit is at
	its estimated end of life. The actual life
	remaining might be different than the
	estimation. Have a replacement transfer kit
	available to install when print quality is no
	longer acceptable. The transfer kit does not
	need to be replaced now unless the print
	quality is no longer acceptable. After a
	transfer kit has reached its approximated end
	of life, HP’s premium Protection Warranty on
	that transfer kit ends.

Replace the transfer kit. Instructions are included with the transfer kit.

Request accepted please wait	The product has accepted a request to print	No action is necessary.
	an internal page, but the current job must
	finish printing before the internal page will
	print.
Resend Upgrade	The firmware upgrade was not completed	Attempt upgrade again.
	successfully.
Resetting kit count	You have selected the option to reset the	No action is necessary.
	count for a new supply item.
Restoring factory settings	The product is restoring factory settings.	No action is necessary.
Restoring...	The product is restoring settings.	Please wait until the process is complete.

RESTRICTED FROM PRINTING IN COLOR This message appears when color printing is disabled for the product or when it is disabled for a particular user or print job.

To enable color printing for the product, change the RESTRICT COLOR USE setting in the Manage supplies menu on page 16.

ROM DISK DEVICE FAILURE	The specified device has failed.	Press the OK button to clear.
To clear press OK

ENWW Interpret control-panel messages 199