Media Drive Removal for Models 380, 390, 39H, and 397
Notes:
1.For a translation of this notice, see System Unit Safety Information.
2.This caution only applies to the
CAUTION:
A Class 3 laser is contained in the device. Do not attempt to operate the device while it is disassembled. Do not attempt to open the covers of the device, as it is not serviceable and is to be replaced as a unit.
Removal
1.Remove any media from the drive.
2.Set the power switches of the attached devices to Off.
3.Set the power switch of the system unit to Off.
4.Do the ªTop Coverº removal procedure on page
5.Do the ªFront Coverº removal procedure on page
6.Disconnect the power cable and SCSI connectors from the media devices.
7.Push the latch on the left inside of the metal cover housing to release the media drive from the housing.
8.Slide the drive assembly out the front.
9.Record the address.
10.Remove the four rail screws to detach the drive assembly from the rails. Retain the screws.
