Voltage Regulator Card (Model 39H)

Note: Refer to ªHandling Static-Sensitive Devicesº on page 3-2 before removing or installing the CPU card in this system.

Removal

1.Set the power switches of the attached devices to Off.

2.Set the power switch of the system unit to Off.

3.Set the key mode switch to the Service position.

4.Remove the top cover by loosening the two thumbscrews located on the back of the system unit. Slide the cover to the rear of the system unit and lift it straight up.

5.Remove the CPU support bracket.

6.Pull up on the CPU card and the voltage regulator card at the same time.

7.Unplug the voltage regulator card from the CPU card.

8.Remove the voltage regulator card from its slot.

CPU Support Bracket

CPU Card

 

Voltage

Regulator

Card

Replacement

1.Plug the voltage regulator card into the CPU card.

2.Align the voltage regulator card and the CPU card with the card guides and the card connectors, and then press the voltage regulator card and the CPU card down into the connectors.

3.Replace the CPU support bracket.

4.Replace the top cover.

5.Set the power switch of the system unit to On.

6.Set the power switches of the attached devices to On.

Removal and Replacement Procedures 3-33

Page 92
Image 92
IBM 7012 manual Voltage Regulator Card Model 39H, CPU Support Bracket CPU Card Voltage Regulator