No indication that Bin X is Full OR No indication that Bin X is Near Full
Note: The NF or Near Full sensor will only be displayed on models that support an Output Expander that has a Dual Sensor installed.
| FRU | Action |
|
|
|
1 | Dual Output Bin X Sensor | Check for correct installation of |
| Assembly | the sensor cable at J5 on the |
| Control Board | control board. If either the Bin Full |
|
| (F) or Bin Near Full (NF) fail the |
|
| sensor test then check the voltage |
|
| at |
|
| measures approximately +5 V dc. |
|
| If the voltage is incorrect, replace |
|
| the control board. If correct, |
|
| replace the sensor assembly. |
|
|
|
Paper Feed Service Check
If you have a 936 Transport Motor Error go to the “Main Drive Service Check” on page
| FRU | Action |
|
|
|
1 | Alignment Assembly | Check to ensure the alignment |
|
| assembly is correctly attached to the |
|
| left side frame and the mounting |
|
| screws are tight. Check the |
|
| alignment assembly for any signs of |
|
| worn rollers, contaminated rollers or |
|
| binds. Replace the alignment |
|
| assembly if any problem is found. |
|
|
|
2 | Inner Deflector | Check the inner paper deflector for |
|
| correct installation. If the deflector is |
|
| bowed or not fitting correctly, replace |
|
| the deflector. |
|
|
|
