Lexmark 4059-XXX manual Duplex Board, Duplex Front Cover Assembly, Duplex Front Cover Door

Models: 4059-XXX

1 347
Download 347 pages 31.81 Kb
Page 184
Image 184

4059-XXX

Duplex Board

1.Lift the base printer from the duplex assembly.

2.Remove the four duplex board cover mounting screws.

3.Gently disconnect the cables from the duplex board. Use caution to avoid damage to the cables and connectors.

4.Remove the two duplex board mounting screws and remove the duplex board.

Duplex Front Cover Assembly

1.Lift the base printer from the duplex assembly.

2.Remove the four duplex board cover mounting screws and disconnect the duplex cover door switch cable at connector J6.

3.Position the duplex assembly on its side.

4.Gently release the three front cover assembly latches from the bottom of the duplex assembly.

5.Remove the duplex front cover assembly.

Duplex Front Cover Door

1.Remove the duplex front cover assembly.

2.Holding the front of the assembly away from you, open the cover door and gently pry the left side door pivot from the mounting.

3.Move the cover door to the left to clear the right door pivot from the mounting and remove the duplex front cover door.

Duplex Front Cover Door Switch

1.Remove the duplex front cover assembly.

2.Remove the four duplex board cover screws and disconnect the cover door switch cable at connector J6.

3.Loosen the cover door switch mounting screw and remove the switch.

Note: Be sure the cover door switch is properly positioned in the mounting slots when reinstalling to allow the duplex cover door actuator arm to operate the switch.

4-214059 Service Manual

Page 184
Image 184
Lexmark 4059-XXX manual Duplex Board, Duplex Front Cover Assembly, Duplex Front Cover Door Switch