4059-XXX
| FRU | Action |
|
|
|
4 | Engine Board | Check the +42 V dc test point on the |
|
| engine board. Go to “Engine Board” |
|
| on page |
|
| find the +42 V dc test point. Be careful |
|
| not to short between the test point and |
|
| any other pin. The voltage measures |
|
| approximately +42 V dc. If correct, |
|
| replace the engine board. |
|
|
|
5 | LVPS Interconnect Board | Check the voltage at |
|
| LVPS. It measures approximately |
|
| +42 V dc. If incorrect, replace the |
|
| LVPS. If correct, replace the |
|
| interconnect board. |
|
|
|
Input Sensor Service Check
Service Tip: Run the base sensor test. Check the input sensor for proper operation. The display changes from open to closed as the sensor flag is manually moved in and out of the sensor.
Service Tip: Run a Diagnostic Print Test in the continuous mode with the controller board removed. A defective input sensor or circuit causes the first copy to exit only partially through the fuser assembly.
| FRU | Action |
|
|
|
1 | Input Sensor Flag | Check the input sensor flag for |
|
| damage and proper operation. If a |
|
| problem is found, repair as |
|
| necessary. |
|
|
|
2 | Engine Board | Check for approximately +5 V dc at |
|
| |
|
| incorrect, replace the engine board. |
|
|
|
3 | Input Sensor Cable | Check the continuity of the input |
|
| sensor cable. If incorrect, replace the |
|
| cable. If correct, replace the input |
|
| sensor assembly. |
|
|
|