Lexmark 4059-XXX manual Configuration ID on

4059-XXX

Error Code	Action
956 Configuration	Indicates a problem with the Configuration ID. This error
ID	occurs because the engine received a configuration ID
	from the controller software which is not valid for the
	level of engine code existing in the printer. Setting the
	configuration ID correctly should fix this error. The ID can
	be set via the NPA data stream or operator panel.
	Note: This error is not generated at POR to allow the
	servicer a method of resetting the configuration ID.
	However, setting the configuration ID is the only
	operation that the servicer can perform. See “Setting
	Configuration ID” on page 3-20.
960 RAM	Indicates a DRAM Memory Error on the controller board.
Memory Error	Replace the controller board.
961 RAM in Slot	Replace the SIMM in Slot 1. If this does not fix the
1 is Bad.	problem, replace the controller board.
962 RAM in Slot	Replace the SIMM in Slot 2. If this does not fix the
2 is Bad.	problem, replace the controller board.
964 Emulation	Indicates a failure within the Download Emulation which
Error	is programmed into the code overlay SIMM. The specific
	error is as follows:
965 Emulation
	964 - Download Emulation CRC Failure. Checksum
Error	Failure.
	965 - Download Emulation Outdated, The Download
	Emulation and the controller code are incompatible. Go
	to “Disabling Download Emulations” on page 3-3 .
975 - 979	The following errors indicate a failure with the network
Network Card X	card in the specified slot. X=any card installed in slots
	1,2 or 3. 975 - Unrecognizable Network Card x. Replace
	Network Card x.
	976 - Unrecoverable software error in Network Card x.
	977 - Controller software detects that a Network Card is
	installed in slot x but cannot establish communications
	with it.
	978 - Bad checksum while programming Network Card
	x. Replace Network Card x.
	979 - Flash parts failed while programming Network
	Card x.
980 <device>	The engine is experiencing unreliable communications
Comm	to the specified device.
981 <device>	The engine protocol violation detected by the specified
	device.

Diagnostic Information 2-6