Lexmark 632, 432, 19Z0101, 832, X860DE, X862DE manual Understanding printer menus 156, Alarms, Timeouts

Understanding printer menus		156
	Menu item	Description
	Alarms	Sets an alarm to sound when the printer requires operator
	Alarm Control	intervention
	Cartridge Alarm	Available selections for each alarm type are:
	Staple Alarm	Off
	Hole Punch Alarm	Single
		Continuous
		Notes:
		• Single is the factory default setting for Alarm Control. Single
		sounds three quick beeps.
		• Off is the factory default setting for Cartridge Alarm and
		Staple Alarm. Off means no alarm will sound.
		• Continuous repeats three beeps every 10 seconds.
		• The Staple Alarm is available only when the finisher is
		installed.
		• The Hole Punch Alarm is only displayed when a finisher with
		hole punch is installed.
	Timeouts	Sets the amount of time the printer is in standby mode
	Standby Mode
	Timeouts	Sets the amount of time the printer waits after a job is printed
	Power Saver	before it goes into a reduced power state
	1–240 min	Notes:
		• 30 minutes is the factory default setting.
		• Lower settings conserve more energy, but may require
		longer warm‑up times.
		• Select the lowest setting if the printer shares an electrical
		circuit with room lighting or you notice lights flickering in the
		room.
		• Select a high setting if the printer is in constant use. Under
		most circumstances, this keeps the printer ready to print
		with minimum warm‑up time.
	Timeouts	Sets the amount of time in seconds the printer waits before
	Screen Timeout	returning the printer display to a Ready state
	15–300 sec	Note: 30 seconds is the factory default setting.
	Timeouts	Sets the amount of time in seconds the printer waits to receive an
	Print Timeout	end‑of‑job message before canceling the remainder of the print job
	Disabled	Notes:
	1–255 sec	• 90 seconds is the factory default setting.
		• When the timer expires, any partially printed page still in the
		printer is printed, and then the printer checks to see if any
		new print jobs are waiting.
		• Print Timeout is available only when using PCL emulation.
		This setting has no effect on PostScript emulation print jobs.