![](/images/new-backgrounds/1258463/258463111x1.webp)
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
| TROUBLESHOOTING & REPAIR |
| |
| TROUBLESHOOTING GUIDE | Observe Safety Guidelines | |
|
| detailed in the beginning of this manual. |
PROBLEMS | POSSIBLE AREAS OF | RECOMMENDED | ||
(SYMPTOMS) | MISADJUSTMENT(S) | COURSE OF ACTION | ||
|
|
|
| |
| OUTPUT PROBLEMS |
|
| |
The machine shuts off (pilot light | 1. The input voltage may be too | 1. | Perform the SCR Bridge Test. | |
goes out and the fans stop) when | high (more than 10% over | 2. | Perform the Power Board | |
the Arc Start Switch or Amptrol is | rated). | |||
| Test. | |||
activated. |
|
| ||
2. The Arc Start switch may be |
|
| ||
| 3. | Perform the Control Board | ||
| faulty. Check or replace. | |||
|
| Test. | ||
|
|
| ||
|
| 4. | Shunt may be faulty or over- | |
|
|
| heated. Check for loose con- | |
|
|
| nections and replace shunt if | |
|
|
| necessary. |
The 115VAC receptacle does not | 1. | The circuit breaker CB1 may | 1. | The circuit breaker may be |
work. The machine operates nor- |
| have opened. Reset if neces- |
| faulty. Test or replace. |
mally. |
| sary. | 2. | If the fans are running, check |
|
|
| ||
| 2. | Check for the presence of |
| the receptacle and the associ- |
|
| 115VAC at the receptacle. |
| ated wiring. |
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, con- tact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed. Call
SQUARE WAVE TIG 355