Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
INPUT CONTACTOR TEST
WARNING
Service and repair should be performed by only Lincoln Electric factory trained personnel. Unauthorized repairs performed on this equipment may result in danger to the technician or machine operator and will invalidate your factory warranty. For your safety and to avoid electri- cal shock, please observe all safety notes and precautions detailed throughout this manual.
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, contact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed. Call
TEST DESCRIPTION
This test will determine if the input contactor is receiving the correct coil voltage and if the con- tacts are functioning correctly.
MATERIALS NEEDED
Volt/Ohmmeter (Multimeter) 5/16" Nut driver External 120 VAC supply
Input Contactor (CR1) Simplified Control Circuit, Figure F.6
Square Wave TIG Wiring Diagram (located in the Electrical Diagrams section of this manual)
SQUARE WAVE TIG 355
