Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
| TROUBLESHOOTING & REPAIR |
| |
| TROUBLESHOOTING GUIDE | Observe Safety Guidelines | |
|
| detailed in the beginning of this manual. |
PROBLEMS | POSSIBLE AREAS OF | RECOMMENDED | ||
(SYMPTOMS) | MISADJUSTMENT(S) | COURSE OF ACTION | ||
|
|
|
|
|
|
| FUNCTION PROBLEMS |
|
|
1. In Stick mode the machine | 1. | If the machine is in the Remote | 1. | If the machine works properly |
welds at a very low output, |
| control mode, make sure a |
| in Local control mode but not |
regardless of the peak current |
| Lincoln remote control device |
| in Remote mode, perform the |
control setting. |
| is connected to the amphenol. |
| Protection Board Test. |
| 2. | The Start Current may be set | 2. | If the machine operates prop- |
|
| too low for the electrode size |
| erly in TIG mode but not in |
|
| being used. |
| Stick mode, the control board |
| 3. If the machine works properly |
| may be faulty. Replace. | |
|
|
| ||
|
| in Local control mode, check | 3. | If the output is low in all |
|
| or replace the remote control |
| modes, perform the SCR |
|
| device. |
| Bridge Test. |
| 4. | If the machine works properly | 4. | The power board may be |
|
| in TIG mode, contact your |
| faulty. Replace. |
|
| local authorized Lincoln | 5. | The control board may be |
|
| Electric Field Service Facility. | ||
|
|
| faulty. Replace. | |
|
|
|
| |
|
|
|
|
|
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, con- tact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed. Call
SQUARE WAVE TIG 355