Lincoln Electric SVM118-A service manual PC Board Troubleshooting Procedures and Replacement

Models: SVM118-A

1 149
Download 149 pages 43.8 Kb
Page 52
Image 52

TOC

F-3

F-3

TROUBLESHOOTING & REPAIR

PC BOARD TROUBLESHOOTING PROCEDURES AND REPLACEMENT

Return to Section

Return to Section TOC

Return to Master

Return to Master TOC

WARNING

ELECTRIC SHOCK can kill.

Have an electrician install and ser- vice this equipment. Turn the machine OFF before working on

equipment. Do not touch electrically hot parts.

Sometimes machine failures appear to be due to PC board failures. These problems can sometimes be traced to poor electrical connections. To avoid prob- lems when troubleshooting and replacing PC boards, please use the following procedure:

1.Determine to the best of your technical ability that the PC board is the most likely component causing the failure symptom.

2.Check for loose connections at the PC board to assure that the PC board is properly connected.

3.If the problem persists, replace the suspect PC board using standard practices to avoid static elec- trical damage and electrical shock. Read the warn- ing inside the static resistant bag and perform the following procedures.

Remove the PC Board from the static-shielding bag and place it directly into the equpment. Don’t set the PC Board on or near paper, plastic or cloth which could have a static charge. If the PC Board can’t be installed immediately, put it back in the sta- tic-shielding bag.

If the PC Board uses protective shorting jumpers, don’t remove them until installation is complete.

If you return a PC Board to The Lincoln Electric Company for credit, it must be in the static-shield- ing bag. This will prevent further damage and allow proper failure analysis.

4.Test the machine to determine if the failure symp- tom has been corrected by the replacement PC board.

NOTE: Allow the machine to heat up so that all elec- trical components can reach their operating temperature.

5. Remove the replacement PC board and substitute

it with the original PC board to recreate the original

problem.

a. If the original problem does not reappear

by substituting the original board, then the

PC board was not the problem. Continue

to look for bad connections in the control

wiring harness, junction blocks, and termi-

nal strips.

Return to Section TOC

Return to Master TOC

ATTENTION Static-Sensitive Devices Handle only at Static-Safe Workstations

Resuable

Container

Do Not Destroy

PC Board can be damaged by static electricity.

Remove your body’s static charge before opening the stat- ic-shielding bag. Wear an anti- static wrist strap. For safety, use a 1 Meg ohm resistive cord connected to a grounded part of the equipment frame.

If you don’t have a wrist strap, touch an unpainted, grounded part of the equipment frame. Keep touching the frame to pre- vent static build-up. Be sure not to touch any electrically live parts at the same time.

b. If the original problem is recreated by the

substitution of the original board, then the

PC board was the problem. Reinstall the

replacement PC board and test the

machine.

6. Always indicate that this procedure was followed

when warranty reports are to be submitted.

NOTE: Following this procedure and writing on the warranty report, “INSTALLED AND SWITCHED PC BOARDS TO VERIFY PROB- LEM,” will help avoid denial of legitimate PC board warranty claims.

Return to Section TOC

Return to Master TOC

Tools which come in contact with the PC Board must be either conductive, anti-static or static-dis- sipative.

SQUARE WAVE TIG 355

Page 52
Image 52
Lincoln Electric SVM118-A service manual PC Board Troubleshooting Procedures and Replacement