A-4

A-4

INSTALLATION

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

STACKING

RANGER 10-LX machines CANNOT be stacked.

TILTING

Place the machine on a secure, level surface whenev- er you use it or store it. Any surfaces you place it on other than the ground must be firm, non-skid, and structurally sound.

The diesel engine is designed to run in a level position for best performance. It can operate at an angle, but this should never be more than 20 degrees in any direction. If you do operate it at a slight angle, be sure to check the oil regularly and keep the oil level at the FULL mark as it would be in its normal level condition. Also, fuel capacity will be a little less at an angle.

LIFTING

The RANGER 10-LX weighs 1100 lbs/499 kg. A lift bail is mounted to the machine frame and should always be used when lifting the machine.

HIGH ALTITUDE OPERATION

It may be necessary to derate welder output at higher altitudes. Derate the welder output 0.4% for every 100 ft (30 m) above 500 ft (150 m). Some engine adjust- ment may be required. Contact a Kubota Service Representative.

PRE-OPERATION ENGINE SERVICE

Read and understand the information about the diesel engine in the Operation and Maintenance sections of this manual before you operate the RANGER 10-LX.

OIL

The RANGER 10-LX is shipped with the engine filled with SAE 10W-30 oil (API class

CC/DO). CHECK THE OIL LEVEL BEFORE YOU START THE ENGINE. This is an added precaution. When full, the oil level should be up to but not over the FULL mark on the dipstick. If it is not full, add enough oil to fill it to the full mark.

For more oil fill and service information, see the Maintenance section of this manual.

FUEL

Fill the fuel tank with clean, diesel fuel only.

The RANGER 10-LX has a 10 gallon (38 litre) fuel tank with a top fill and fuel gauge mounted on the control panel. See the

Operation and Maintenance sections of this manual for more details about fuel.

ENGINE COOLANT

WARNING

HOT COOLANT can burn skin.

• Do not remove cap if radiator is hot.

The welder is shipped with the engine and radiator filled with a 50% mixture of ethylene glycol and water. The recovery bottle should be partially filled. See the Maintenance section and the engine Operator’s Manual for more information on coolant.

Return to Section TOC

Return to Master TOC

WARNING

Keep hands away from the engine muffler or HOT engine parts.

Stop the engine when fueling.

Do not smoke when fueling.

Remove the fuel cap slowly to release pressure.

Do not overfill the fuel tank.

Wipe up spilled fuel and allow the fumes to clear before starting the engine.

Keep sparks and flame away from the fuel tank.

BATTERY CONNECTIONS

+ The RANGER 10-LX is shipped with the negative battery cable disconnected.

Before you operate the machine, make

sure the Engine Switch is in the STOP position and attach the disconnected cable securely to the battery terminal. If the battery is discharged and won’t start the engine, see the battery charging instructions in the Maintenance section.

RANGER 10-LX

Page 10
Image 10
Lincoln Electric SVM120-A service manual PRE-OPERATION Engine Service