
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
MAINTENANCE
FIGURE D.1 – OIL DRAIN AND REFILL LOCATION
4
1
3
2 | 1. | DIPSTICK | 3. | OIL FILTER |
| ||||
| 2. | OIL DRAIN PLUG | 4. | OIL FILL CAP |
CHANGE THE OIL FILTER
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Change the oil filter the first time after 50 hours of operation. Then, under normal operating conditions, change the oil filter after every 200 hours of operation. If the engine is operated under heavy load or in high ambient temperatures, change the oil filter more fre- quently. See Table D.1 for recommended mainte- nance intervals.
Change the oil filter as follows:
1.Drain the oil from the engine and allow the oil filter to drain.
2.Remove the old filter (spin it off) and discard it. Wipe off the filter mounting surface and adapter.
3.Apply a thin coat of new oil to the rubber gasket on the new oil filter.
4.Spin the new filter onto the mounting adapter until the gasket just touches the mounting surface, then turn it down another 1/2 to 3/4 turn. Do not over- tighten the new filter.
5.Refill the engine with the proper amount and type of oil as described in the Change the Oil section, above. Start the engine and check for leaks around the filter element. Correct any leaks (usually by retightening the filter, but only enough to stop leaks) before placing the RANGER
6.If there are no leaks, stop the engine and recheck the oil level. If necessary, add oil to bring the level up to the FULL mark, but do not overfill.
FUEL: At the end of each day’s use, refill the fuel tank to minimize moisture condensation and dirt contamination in the fuel line. Do not overfill; leave room for the fuel to expand.
Use only fresh, No.2 grade DIESEL fuel oil. Do not use kerosene.
FUEL FILTER: Clean the fuel filter every 100 hours of operation. Be sure to clean the fuel filter regularly. Dust and dirt in the fuel system can cause the injection pump and injection nozzle to wear quickly. Clean the fuel filter as follows (See Figure D.2.):
1.Close the fuel filter cock.
2.Loosen the ring screw on the top of the filter pot, remove the pot and remove the element from inside the pot. Clean the inside of the pot with clean diesel fuel.
3.Rinse the element with clean diesel fuel.
RANGER