MAINTENANCE
Return to Section TOC
To reinstall the brushes, press them upward and slide a cable tie or wooden stick through the brush holder tabs. See Figure D.5. Install the brush holder into position and secure with the screws previously removed. Remove the cable tie or wooden stick and the brushes will seat onto the slip rings.
RECEPTACLES: Keep the electrical receptacles in good condition. Remove any dirt, oil, or other debris from their surfaces and holes.
CABLE CONNECTIONS: Check the welding cable connections at the weld output terminals often. Be sure that the connections are always tight.
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
FIGURE D.5 - BRUSH REMOVAL AND REPLACEMENT
1. BRUSHES
2. CABLE TIE
3. RETAINER CLIP
RANGER
