ACCESSORIES
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
7.Place the WIRE FEEDER switch in the “WITH CON- TROL CABLE” position.
8.Adjust wire feed speed at the wire feeder and set the welding voltage with the output “CONTROL” to a CV (constant voltage) position at the welder.
NOTE: If optional remote control is used, place the output control switch in the “CON- TROL REMOTE” position.
CONNECTION OF THE
1.Shut the welder off.
2.Connect the electrode cable from the
NOTE: Welding cable must be sized for current and duty cycle of application.
3.Set the welder “polarity” switch to the desired polarity, either DC
4.Set the “RANGE” switch to the “WIRE FEED” posi- tion.
5.Attach the single lead from the
6.Place the “IDLER” switch in the “AUTO” position.
7.Place the WIRE FEEDER switch in the “NO CON- TROL CABLE” position.
8.Adjust wire feed speed at the
NOTE: If optional remote control is used, place the output control switch in the “CON- TROL REMOTE” position.
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
FIGURE C.2 – RANGER 10-LX/LN-25 ACROSS THE ARC CONNECTION DIAGRAM
K857
RANGER