Muratec F-65 operating instructions 919725552009, Transmit, Dial the fax number, … or …

Insert the document.

Getting started

3 Dial the fax number.

•Enter the fax number by using the numeric keypad and then press START. … or …

•Use one-touchdialing (see page 2.8).

… or …

•Use speed-dialdialing (see page 2.10). … or …

•Use the EasyDail directory (see page 2.13).

4 Now, everything is up to the machines — yours and the one you are dialing.

•If you set the fax to transmit from memory, your machine will first scan the document into memory, then dial the other fax. When it makes con- tact, your machine transmits the stored document from memory.

•If the fax is set for non-memory transmission, your machine simply dials the other fax. When it makes contact, your machine feeds the document through, scanning and transmitting it as it goes.

Note: The more “stuff”, or black coverage, your machine “sees” on a page, the more slowly the page scans it.Even if the page is relatively clean, sending it in grayscale mode or certain resolution settings makes your machine “see” more “stuff”.

The same is true if you set the contrast to Dark.

Note: What if the call fails? See “If the call doesn’t go through: redialing,” next page.

Important: If you want to cancel a transmission in progress, you will need to use the Review Commands function.

See “Canceling sending a document,” page 1.20.

5 At the end of the operation, your fax machine beeps and displays:

** Complete **

Sending a fax with a handset or on-hook dialing (Manual sending)

You also can fax a document by dialing using either the handset or the monitor speaker. This is called “on-hook” dialing.

Here’s how:

1

2 Adjust resolution and contrast if necessary. If these are OK, skip to step 3. If not, press RESOLUTION to change the resolution and/or press CONTRAST to change the contrast.

3 Obtain a dial tone. You can do this by either:

•Lifting a handset. … or …

•Activating the monitor speaker (by pressing MONITOR/CALL) In either case, the LCD shows:

**Tel Mode **

4 Enter the fax number by using the numeric keypad.

919725552009_

Enter access codes along with the number, just as for a regular phone call.

5 When you hear fax tones from the remote unit, press START. The LCD will show:

Transmit

Note: If a person answers the phone, use the handset to tell that person you are sending a fax. When his/her machine sends you fax tones, then press START.

6 If you are using the handset, hang up after pressing START.

7 At the end of the operation, your fax machine beeps and displays:

** Complete **

1.18