Muratec F-65 operating instructions If the call doesn’t go through redialing

Press either MONITOR/CALL or lift the handset to get a dial tone.

If the call doesn’t go through: redialing

Automatic redialing

If you dialed without using either the monitor speaker or the handset and the fax call fails, your machine automatically redials the call.

While your machine is waiting to redial, the LCD shows:

Auto Redial

While in this Auto Redial mode, the machine can receive faxes and make as many as 30 fax transmissions.

Your fax will continue to redial the number every few minutes until one of these hap- pens first:

•It reaches the remote fax machine.

•It has automatically redialed the number for the last try (again, see “Making redial settings,” next column).

Notes: If the last try fails, your machine may print (and/or display) error messages. For more information, see pages 3.4–3.7.

Note: If you used either the speaker or a handset, redial manually (see below).

Redialing manually

You can always redial fax or voice calls manually. And if you dialed using the moni- tor speaker or the handset, you must redial manually.

To redial a fax call manually without using the monitor speaker or the handset:

1 Make sure the document is in the feeder and that the resolution and contrast are set as you want it.

2 Press REDIAL/PAUSE, START.

To redial a fax call manually by using the monitor speaker or the handset:

1 Make sure the document is in the feeder and that the resolution and contrast are set as you want it.

2

3 Press REDIAL/PAUSE.

4 When you hear fax tones from the remote unit, press START.

Note: If a person answers the phone, use the handset to tell that person you are sending a fax. When his/her machine sends you fax tones, then press START.

Getting started

To redial a voice call manually by using the handset:

1 Lift the handset to get a dial tone. Make sure there is not document in the document feeder.

2 Press REDIAL/PAUSE. When the other person answers, speak to him/her on the handset.

Setting the redial

You can determine how many times the fax redials a number and how long it waits during redials (this is called the redial interval). To set the redial:

1 Press PROGRAM, J, 0, 7, ENTER. The LCD shows briefly:

Set # Of Redial

then it shows:

# (02-15): 02

If the number of redialing attempts you see is acceptable, skip to step 3. If not, go on to step 2.

2 To change the setting, use the numeric keypad to enter the desired number of redialing attempts, as few as two or as many as 15. In this example, we have entered 3. Use a leading zero for numbers less than 10.

# (02-15): 03

3 Press ENTER to save the setting.

4 The LCD now shows briefly:

Redial Interval

then it shows:

Interval : 3

The redial interval is shown in minutes. If the redial interval you see is accept- able, skip to step 6.

If not, go on to step 5.

5 To change the setting, use the numeric keypad to enter the desired length. You may enter 3, 4 or 5. In this example, we chose 4.

Interval : 4

6 Press ENTER to save the setting.

1.19