Getting started

Attaching the paper-handling parts

1 Attach the document hopper by inserting its two pegs at a slightly upward angle into the appropriate holes.

2 Attach the document separator into the appropriate holes, as shown.

Plug in and power up

Handset cord

Telephone line cord

1 Plug one end of the curled handset cord into the HANDSET jack on the left side of your machine.

2 Plug the other end of the handset cord into the handset.

3 Place the telephone handset onto the handset cradle.

4 Plug one end of the telephone line cord into the LINE jack on the left side of your machine. Plug the other end of the telephone line cord into a standard telephone wall jack, just as you would plug in a phone.

5

Plug the non-pronged end of the AC power cord into the AC power cord jack on

 

the rear side of the machine.

6 Plug the pronged end of the AC power cord into a 120 VAC electrical outlet (use a surge suppressor, as mentioned on page 1.6).

Note: This will turn on your fax machine.

When you connect the power, the LCD will show:

01/01/1999 0:00 (Day/Month/Year Time)

When the date and time are displayed on the LCD, the fax machine is in the normal standby mode and ready for normal operation. If the machine beeps, the ALARM light glows and the LCD shows an error message, this means there is a problem. If this happens, consult “Just in case...,” beginning on page 3.1.

Setting the paper size

Your machine’s paper cassette can hold either letter- or legal-sized paper. All you have to do is tell the machine which size the cassette is using.

Important: If you use a different size from the one you set here, the machine will not print. Change this setting whenever you load a different size.

1 Press PROGRAM, J, 0, 4, ENTER. The LCD shows the current paper size setting:

PaperSize:Letter

If the setting you see is acceptable, skip to step 3.

If not, go on to step 2.

1.8

Page 16
Image 16
Muratec F-65 Attaching the paper-handling parts, Plug in and power up, Setting the paper size, PaperSizeLetter