Muratec F-65 operating instructions Errors, Error reports, Kinds of error codes, Specific errors

Just in case …

Errors

Your machine occasionally experiences communications errors, which may be caused by anything from lightning to telephone line interference. The fax machine at the other end of the line can also cause communication errors.

Trying your call may be all that’s necessary. However, if the problem persists regu- larly, call your local telephone company for help. If that call does not help and the problem persists regularly, call your authorized Muratec dealer.

Error reports

When an error occurs, your fax machine prints an error report. Each fax error report lists an error message which includes:

•A possible solution to the problem

•The sending location (if the remote fax stores a Location ID of its own)

•The result — which is a special error code.

•A sample of the document’s first page.

Kinds of error codes

The error code listed in the “Result” column of the error report indicates the specific problem encountered:

•“D” codes — Occur while dialing

•“R” codes — Occur during reception

•“T” codes — Occur during transmission

Specific errors

Some of the error codes you may see on an error report:

Dialing errors

D.0.3, D.0.8 The remote unit did not respond, the call could not be completed or

	STOP was pressed while the unit was dialing.
	Try the call again. If your machine repeats the message, call the
	remote fax user to verify that the unit is operating properly.
D.0.2	The remote fax machine is busy. Call again.

D.0.6, D.0.7 Either the remote fax unit did not respond, the call did not go through or someone pressed STOP while the calling fax machine was dialing. Call again.

Reception errors

R.1.1	The calling fax machine did not respond to your fax machine. This can
	happen if someone dials a wrong number or if the remote machine
	restricts access through use of a passcode.
R.1.2	The two fax machines were incompatible. Your fax machine sends and
	receives only ITU-TGroup 3 fax communication, the industry standard
	since the early 1980s.
R.1.4	Someone pressed STOP at the receiving fax machine.
R.2.3	Poor phone line conditions made fax communication impossible.
	Call someone at the remote machine.
R.3.1	The sending fax machine detected too many errors from the receiving
	fax machine.
R.3.3	The sending fax machine is incompatible or had a document feeder
	problem during transmission.
R.3.4	Poor phone line conditions may have prevented your fax machine
	from properly printing some or all of the pages it received.
R.4.2	Either the line disconnected before transmission or the transmitting
	fax machine needs maintenance.
R.4.4	The fax machine has reached its memory capacity.

R.5.1, R.5.2 ECM reception failed.

3.6