Muratec F-65 operating instructions Programming F-code polling, Code Polling

Beyond the basics

13 Instructways: your fax to carry out this delayed command in one of the following

Option 1: Perform the command once at a certain time on a certain day of the month (For example, “Do this at 5:05 PM on the 30th.”)

To select this option, use the numeric keypad to enter the date and time when the fax should perform the command:

Time : 30/17:05

Option 2: Perform the command at a certain time each day you press the key. (For example, “Do this at 5:05 PM today.”)

To select this option, use the numeric keypad to enter 0, 0 (i. e., 00), and then the time when the fax could perform the com- mand:

Time : 00/17:05

14 Press ENTER, ENTER.

15 The display now shows the next programmable one-touch key.

If you do not want to enter or change any other key’s programming, press STOP to return your machine to its usual standby mode.

If you do want to enter or change another key’s programming, go back to step 4.

Programming F-code polling

Note: To erase a programmable one-touch key, refer to page 2.36.

Note: For F-code polling to work, two things must be true:

•The document which you are polling must exist on the remote machine in an F-code (ITU-Tsub-addressing/password) box.

•You must know the remote fax’s ITU-Tsubaddress and (if applicable) pass- word for each box you want to poll.

To program an F-code operation into a programmable one-touch key:

1 Press PROGRAM, C, 1. The LCD shows:

Enter P OneTouch

2 Press ENTER. The LCD either shows:

P1:No Number

… or indicates a command is already programmed into this key.

If P1 is the key you want to program, skip to step 4. (However, our examples from here will say “P3” rather than “P1.”)

3 Select the key in which you want to program a command or change a previ- ously stored command and then press it. Here, we select P3.

P3:No Number

4 If you decide to select a different programmable one-touch key, go back to step 3 before going on to step 5.

5 Press ENTER. The LCD now shows briefly:

P3:Fax Number

then it will show either:

_ or 9-555-7312_

6 Use the numeric keypad to enter the number exactly as your machine should dial it, including whatever codes your phone system may require. The num- ber can be up to 40 characters in length:

9-555-0629_

Important: Do not press ENTER.

Your display can show only 16 characters at a time. To view characters beyond those 16, press to scroll to the left or to scroll to the right.

Note: If you make a mistake or want to erase previously entered numbers, press CANCEL to erase to the left. Or to change just one character in the number, press to move the cursor to the left, or to move it to the right, to that character and press CANCEL to erase it. Then re- enter until the number is just as you want it.

7 Now, while you still can see the fax number on the display, press COM- OPTIONS six times. The LCD shows:

6.F-Code Polling

8 Press ENTER. The LCD shows briefly:

Enter SubAddress

_

2.34