Muratec F-65 operating instructions Group No ,24

2

1

Note:

6 Use the numeric keypad to enter the number exactly as your machine should dial it, including whatever codes your phone system may require. The num- ber can be up to 40 characters in length:

9-555-0629_

P1:No Number

… or indicates a command is already programmed into this key.

If P1 is the key you want to program, skip to step 4. (However, our examples from here will say “P3” rather than “P1.”)

3 Select the key in which you want to program a command or change a previ- ously stored command and then press it. Here, we select P3.

P3:No Number

4 If you decide to select a different programmable one-touch key, go back to step 3 before going on to step 5.

5 Press ENTER. The LCD now shows briefly:

P3:Fax Number

then it will show either:

Programming regular polling or sequential polling

_

9-555-7312_

or

Press ENTER. The LCD shows either:

Press PROGRAM, C, 1. The LCD shows:

Enter P OneTouch

To program a polling operation into a programmable one-touch key:

To erase a programmable one-touch key, refer to page 2.36.

9 Use the numeric keypad to enter the two-digit identifier (01–32) for the first call group. You can specify up to 10 separate groups for each relay broadcast initiation. Between the entry of each new group, press COM-OPTIONSto insert a comma. Do not insert a comma after the last group number.

For example, here, we enter 0, 4, COM-OPTIONS, 1, 1, COM-OPTIONS, 2, 4:

Group No. 1,24_

Note: The LCD shows only four characters at a time.

Important: Again, do not insert a comma after the last group number.

When finished, press ENTER.

10 If you want the transmission to begin immediately every time you press the key, press ENTER and skip to step 13.

If you want to delay the transmission, press COM-OPTIONS,COM-OPTIONS,

ENTER.

11 Instructways: your fax to carry out this delayed command in one of the following

Option 1: Perform the command once at a certain time on a certain day of the month. (For example, “Do this at 5:05 PM on the 30th.”)

To select this option, use the numeric keypad to enter the date and time when the fax should perform the command:

Time : 30/17:05

Option 2: Perform the command at a certain time each day you press the key. (For example, “Do this at 5:05 PM today.”)

To select this option, use the numeric keypad to enter 0, 0 (i. e., 00), and then the time when the fax could perform the command:

Time : 00/17:05

12 Press ENTER, ENTER.

13 The LCD now displays the next programmable one-touch key.

If you do not want to enter or change any other key’s programming, press STOP to return your machine to its usual standby mode.

If you do want to enter or change another key’s programming, go back to step 4.

Beyond the basics

Important: Do not press ENTER.

If performing regular (not sequential) polling, skip to step 8.

If performing sequential polling, proceed to step 7.

2.31