ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-67
v1.0, November 2010
dot1x guest-vlan
This command configures VLAN as guest vlan on a per port basis. The command specifies an
active VLAN as an IEEE 802.1x guest VLAN. The range is 1 to the maximum VLAN ID
supported by the platform.
no dot1x guest-vlan
This command disables Guest VLAN on the interface.
dot1x initialize
This command begins the initialization sequence on the specified port. This command is only valid
if the control mode for the specified port is “auto” or “mac-based”. If the control mode is not 'auto'
or “mac-based”, an error will be returned.
dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The <count>
value must be in the range 1 - 10.
Default disabled
Format dot1x guest-vlan <vlan-id>
Mode Interface Config
Default disabled
Format no dot1x guest-vlan
Mode Interface Config
Format dot1x initialize <unit/slot/port>
Mode Privileged EXEC
Default 2