ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Quality of Service (QoS) Commands 5-26
v1.0, November 2010
The service commands attach a defined policy to a directional interface. You can assign only one
policy at any one time to an interface in the inbound direction. DiffServ is not used in the outbound
direction.
This set of commands consists of service addition/removal.
The CLI command root is service-policy.
service-policy
This command attaches a policy to an interface in the inbound direction. The <policyname>
parameter is the name of an existing DiffServ policy. This command causes a service to create a
reference to the policy.
Note: This command effectively enables DiffServ on an interface in the inbound
direction. There is no separate interface administrative 'mode' command for
DiffServ.
Note: This command fails if any attributes within the policy definition exceed the
capabilities of the interface. Once a policy is successfully attached to an interface,
any attempt to change the policy definition, that would result in a violation of the
interface capabilities, causes the policy change attempt to fail.
Format service-policy in <policymapname>
Modes • Global Config
• Interface Config
Note: Each interface can have one policy attached.