ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Routing Commands 4-15
v1.0, November 2010
The following shows example CLI display output for the command.
(switch)#show ip interface 1/0/2
Routing Interface Status....................... Down
Primary IP Address............................. 1.2.3.4/255.255.255.0
Secondary IP Address(es)....................... 21.2.3.4/255.255.255.0
............................................... 22.2.3.4/255.255.255.0
Helper IP Address.............................. 1.2.3.4
............................................... 1.2.3.5
Term Definition
Routing
Interface Status Determine the operational status of IPv4 routing Interface. The possible values are Up or
Down.
Primary IP
Address The primary IP address and subnet masks for the interface. This value appears only if you
configure it.
Secondary IP
Address One or more secondary IP addresses and subnet masks for the interface. This value
appears only if you configure it.
Helper IP
Address The helper IP addresses configured by the “ip helper-address (Global Config)command.
Routing Mode The administrative mode of router interface participation. The possible values are enable
or disable. This value is configurable.
Administrative
Mode The administrative mode of the specified interface. The possible values of this field are
enable or disable. This value is configurable.
Forward Net
Directed
Broadcasts
Displays whether forwarding of network-directed broadcasts is enabled or disabled. This
value is configurable.
Proxy ARP Displays whether Proxy ARP is enabled or disabled on the system.
Local Proxy ARPDisplays whether Local Proxy ARP is enabled or disabled on the interface.
Active State Displays whether the interface is active or inactive. An interface is considered active if its
link is up and it is in forwarding state.
Link Speed Data
Rate An integer representing the physical link data rate of the specified interface. This is
measured in Megabits per second (Mbps).
MAC Address The burned in physical address of the specified interface. The format is 6 two-digit
hexadecimal numbers that are separated by colons.
Encapsulation
Type The encapsulation type for the specified interface. The types are: Ethernet or SNAP.
IP MTU The maximum transmission unit (MTU) size of a frame, in bytes.
Bandwidth Shows the bandwidth of the interface.
Destination
Unreachables Displays whether ICMP Destination Unreachables may be sent (enabled or disabled).
ICMP Redirects Displays whether ICMP Redirects may be sent (enabled or disabled).