ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-5
v1.0, November 2010
description
Use this command to create an alpha-numeric description of the port.
mtu
Use the mtu command to set the maximum transmission unit (MTU) size, in bytes, for frames that
ingress or egress the interface. You can use the mtu command to configure jumbo frame support
for physical and port-channel (LAG) interfaces. For the standard 7000 series implementation, the
MTU size is a valid integer between 1522 - 9216 for tagged packets and a valid integer between
1518 - 9216 for untagged packets.
no mtu
This command sets the default MTU size (in bytes) for the interface.
Format description <description>
Mode Interface Config
Note: To receive and process packets, the Ethernet MTU must include any extra bytes
that Layer-2 headers might require. To configure the IP MTU size, which is the
maximum size of the IP packet (IP Header + IP payload), see “ip mtu” on page 4-
12.
Default 1518 (untagged)
Format mtu <1518-9216>
Mode Interface Config
Format no mtu
Mode Interface Config