ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-197
v1.0, November 2010
ISDP Commands
This section describes the commands you use to configure the industry standard Discovery
Protocol (ISDP).
isdp run
This command enables ISDP on the switch.
no isdp run
This command disables ISDP on the switch.
isdp holdtime
This command configures the hold time for ISDP packets that the switch transmits. The hold time
specifies how long a receiving device should store information sent in the ISDP packet before
discarding it. The range is given in seconds.
Default Enabled
Format isdp run
Mode Global Config
Format no isdp run
Mode Global Config
Default 180 seconds
Format isdp holdtime <10-255>
Mode Global Config