ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-53
v1.0, November 2010
vlan port priority all
This command configures the port priority assigned for untagged packets for all ports presently
plugged into the device. The range for the priority is 0-7. Any subsequent per port configuration
will override this configuration setting.
vlan priority
This command configures the default 802.1p port priority assigned for untagged packets for a
specific interface. The range for the priority is 0–7.
Protected Ports Commands
This section describes commands you use to configure and view protected ports on a switch.
Protected ports do not forward traffic to each other, even if they are on the same VLAN. However,
protected ports can forward traffic to all unprotected ports in their group. Unprotected ports can
forward traffic to both protected and unprotected ports. Ports are unprotected by default.
If an interface is configured as a protected port, and you add that interface to a Port Channel or
Link Aggregation Group (LAG), the protected port status becomes operationally disabled on the
interface, and the interface follows the configuration of the LAG port. However, the protected port
configuration for the interface remains unchanged. Once the interface is no longer a member of a
LAG, the current configuration for that interface automatically becomes effective.
Format vlan port priority all <priority>
Mode Global Config
Default 0
Format vlan priority <priority>
Mode Interface Config