ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Utility Commands 6-20
v1.0, November 2010
no logging console
This command disables logging to the console.
logging host
This command enables logging to a host. You can configure up to eight hosts. The
<ipaddr|hostname> is the IP address of the logging host. The <addresstype> indicates
the type of address ipv4 or ipv6 or dns being passed. The <port> value is a port number from 1
to 65535. You can specify the <severitylevel> value as either an integer from 0 to 7 or
symbolically through one of the following keywords: emergency (0), alert (1), critical
(2), error (3), warning (4), notice (5), info (6), or debug (7).
logging host remove
This command disables logging to host. See “show logging hosts” on page 6-22 for a list of host
indexes.
logging syslog
This command enables syslog logging. The <portid> parameter is an integer with a range of 1-
65535.
Format no logging console
Mode Global Config
Default • port—514
• level—critical (2)
Format logging host <ipaddr|hostname> <addresstype>
[<port>][<severitylevel>]
Mode Global Config
Format logging host remove <hostindex>
Mode Global Config
Default disabled
Format logging syslog [port <portid>]
Mode Global Config