ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Quality of Service (QoS) Commands 5-9
v1.0, November 2010
show interfaces cos-queue
This command displays the class-of-service queue configuration for the specified interface. The
unit/slot/port parameter is optional and is only valid on platforms that support independent per-
port class of service mappings. If specified, the class-of-service queue configuration of the
interface is displayed. If omitted, the most recent global configuration settings are displayed.
If you specify the interface, the command also displays the following information.
Differentiated Services (DiffServ) Commands
This section describes the commands you use to configure QOS Differentiated Services
(DiffServ).
You configure DiffServ in several stages by specifying three DiffServ components:
1. Class
Format show interfaces cos-queue [<unit/slot/port>]
Mode Privileged EXEC
Term Definition
Queue Id An interface supports n queues numbered 0 to (n-1). The specific n value is platform
dependent.
Minimum
Bandwidth The minimum transmission bandwidth guarantee for the queue, expressed as a
percentage. A value of 0 means bandwidth is not guaranteed and the queue operates
using best-effort. This is a configured value.
Scheduler Type Indicates whether this queue is scheduled for transmission using a strict priority or a
weighted scheme. This is a configured value.
Queue
Management
Type
The queue depth management technique used for this queue (tail drop).
Term Definition
Interface The unit/slot/port of the interface. If displaying the global configuration, this output line is
replaced with a Global Config indication.
Interface
Shaping Rate The maximum transmission bandwidth limit for the interface as a whole. It is independent
of any per-queue maximum bandwidth value(s) in effect for the interface. This is a
configured value.