ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Quality of Service (QoS) Commands 5-49
v1.0, November 2010
Auto-Voice over IP Commands
This section describes the commands you use to configure Auto-Voice over IP (VoIP) commands.
The Auto-VoIP feature explicitly matches VoIP streams in Ethernet switches and provides them
with a better class-of-service than ordinary traffic. When you enable the Auto-VoIP feature on an
interface, the interface scans incoming traffic for the following call-control protocols:
• Session Initiation Protocol (SIP)
• H.323
• Skinny Client Control Protocol (SCCP)
When a call-control protocol is detected, the switch assigns the traffic in that session to the highest
CoS queue, which is generally used for time-sensitive traffic.
auto-voip all
Use this command to enable VoIP Profile on the interfaces of the switch.
no auto-voip all
Use this command to disable VoIP Profile on the interfaces of the switch.
IP DSCP The value specified for IP DSCP.
Flow Label The value specified for IPv6 Flow Label.
Log Displays when you enable logging for the rule.
Assign Queue The queue identifier to which packets matching this rule are assigned.
Mirror Interface The unit/slot/port to which packets matching this rule are copied.
Redirect
Interface The unit/slot/port to which packets matching this rule are forwarded.
Default disabled
Format auto-voip all
Mode Global Config
Term Definition