ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Management Commands 7-7
v1.0, November 2010
The following shows example CLI display output for the network port.(Netgear Switch) #show network
Interface Status............................... Always Up
IP Address..................................... 10.250.3.1
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.250.3.3
IPv6 Administrative Mode....................... Enabled
IPv6 Address/Length is ........................ FE80::210:18FF:FE82:337/64
IPv6 Address/Length is ........................ 3099::1/64
IPv6 Address/Length is ........................ 3099::210:18FF:FE82:337/64
IPv6 Default Router is ........................ FE80::204:76FF:FE73:423A
Burned In MAC Address.......................... 00:10:18:82:03:37
Locally Administered MAC Address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Term Definition
Interface Status The network interface status; it is always considered to be “up”.
IP Address The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway The default gateway for this IP interface. The factory default value is 0.0.0.0.
IPv6
Administrative
Mode
Whether enabled or disabled.
IPv6 Address/
Length The IPv6 address and length.
IPv6 Default
Router The IPv6 default router address.
Burned In MAC
Address The burned in MAC address used for in-band connectivity.
Locally
Administered
MAC Address
If desired, a locally administered MAC address can be configured for in-band connectivity.
To take effect, 'MAC Address Type' must be set to 'Locally Administered'. Enter the
address as twelve hexadecimal digits (6 bytes) with a colon between each byte. Bit 1 of
byte 0 must be set to a 1 and bit 0 to a 0, i.e. byte 0 should have the following mask 'xxxx
xx10'. The MAC address used by this bridge when it must be referred to in a unique
fashion. It is recommended that this be the numerically smallest MAC address of all ports
that belong to this bridge. However it is only required to be unique. When concatenated
with dot1dStpPriority a unique BridgeIdentifier is formed which is used in the Spanning
Tree Protocol.
MAC Address
Type The MAC address which should be used for in-band connectivity. The choices are the
burned in or the Locally Administered address. The factory default is to use the burned in
MAC address.