Nortel Networks Remote Gateway 50 manual Procedure Configuring the branch office zone

		Emergency Services configuration Page 237 of 258
LD 90 – Configure ESN Special Number and Digit Manipulation. (Part 2 of 2)
Prompt	Response	Description
- SDRR		Supplemental Digit Restriction or Recognition
	ALOW	Allowed codes
	ARRN	Alternate Routing Remote Number
	DDD	Recognized remote Direct Distance Dial codes
	DENY	Restricted codes
	DID	Recognized remote Direct Inward Dial codes
	ITED	Incoming Trunk group Exclusion Digits
	LDDD	Recognized Local Direct Distance Dial codes
	LDID	Recognized Local Direct Inward Dial codes
	STRK	For ADM/MDM trunk groups
	<cr>	Return to SPN
- - DMI	1-255	Digit Manipulation Index
	1-999	Digit Manipulation Index with FNP
		DMI is only prompted when the Directory Number
		Expansion (DNXP) package 150 is equipped and
		SDRR = LDID.

Procedure 16

Configuring the branch office zone

1Configure the branch office zone on the branch office.

In the branch office, only the zone number and bandwidth/codec selection is configured.

Note: Use the same zone number between the branch office and main office. The main office configuration (Procedure 15, step 6 on page 232) provides the branch office zone characteristics (local time, local dialing, and ESA).

2Configure the routing tables on the SRG.

The SRG must recognize the incoming digits on the Virtual Trunk and remove all but the ESDN. The call is routed to a local termination.

End of Procedure

Main Office Configuration for Survivable Remote Gateway 50 Configuration Guide