Setting up the main office Page 39 of 258

Table 3

Main office interoperation information (Part 3 of 3)

Main office components

Information about this system

 

 

Zone dialing:

 

• ZDP appended to SRG IP Phone PSTN

 

dialing strings to redirect the call to SRG

 

PSTN

 

• Any steering codes (destination codes)

 

that must be mirrored by SRG

 

programming

 

 

 

IP Phone configuration:

 

 

 

MOTN/BUID list, including which type of

 

IP Phone is assigned to each number

 

Note: Make note of the leading number, as

 

SRG uses this as the DN range for CDP

 

dialing. If the DCP access code is more than

 

one digit, the second digit number must also

 

be used to further define the DN range.

 

 

 

Current IP Phone firmware version

 

 

 

Is a VLAN configured on the network?

 

 

 

Zone parameters

Zone parameters must be configured at both the main office Call Server and the SRG. The main office procedure is similar to an IP Peer Network configuration with the branch office-specific configuration outlined in this chapter.

Zone parameters are defined at the main office in LD 117 (see Procedure 1 on page 40) and applied to IP Phones in LD 11.

Use Procedure 1 on page 40 to configure ESN and SRG zones.

Main Office Configuration for Survivable Remote Gateway 50 Configuration Guide

Page 39
Image 39
Nortel Networks Remote Gateway 50 manual Zone parameters, Pstn