B2520 / B2540
9 | Adjust the contrast level with the buttons | or , |
| then confirm with the OK button. |
|
10 | Adjust the desired brightness level with the buttons | |
| or , then confirm with the OK button. |
|
11 Choose the paper type NORMAL, THICK with the buttons or , then confirm with the OK button.
Special setup for the copying
Setups done through this menu become the device default setups after you confirm.
When the quality of the printing is not satisfying, you can proceed to a calibration (see Calibrate your scanner, page 29).
Resolution setup
The RESOLUTION parameter allows you to setup the photocopy resolution.
841 - ADVANCED FCT/COPY/RESOLUTION
1 Choose the resolution with the buttons | or | ||
according to the following table:. |
| ||
Parameter |
| Signification |
|
|
| ||
|
|
|
|
|
|
|
|
DRAFT |
| Low resolution. |
|
|
|
| |
AUTO |
| Standard resolution for documents | |
| containing text and graphics. |
| |
|
|
| |
|
|
| |
QUALITY |
| Optimal resolution for documents | |
TEXT |
| containing text. |
|
|
|
| |
PHOTO |
| Optimal resolution for documents | |
| containing photographies. |
| |
|
|
| |
|
|
|
|
2Confirm your choice by pressing the OK button.
You can also change the resolution by
pressing the 
button.
Zoom setup
The ZOOM parameter allows you to reduce or enlarge an area of a document by choosing the origin and the zoom level to apply to the document, from 25 to 400 %.
842 - ADVANCED FCT/COPY/ZOOMING
1 Enter the desired zoom level with the Alpanumerical keyboard or choose among predefined values with the buttons and .
2Confirm your choice by pressing the OK button.
Assembled copy setup
843 - ADVANCED FCT/COPY/ASSEMBLED | Copy- | |
The ASSEMBLED parameter allows you to assemble or | ||
disassemble your copies. Enter the desired setting and | 3 | |
confirm your choice by pressing the OK button. | ||
|
Analysis origin setup
If you want, you can change the origin of the scanner.
By entering new values for X and Y in mm (X < 209 and Y < 280), you move the analysed area as shown on the diagram below.
BEGIN.OF SHEET | OFENDSHEET |
|
| x |
|
|
| Analysed area |
| y |
|
844 - ADVANCED FCT/COPY/ORIGIN
1Select the X and Y coordinates with the buttons or .
2Setup the desired coordinates with the digital
keyboard or the buttons and , confirm your choice by pressing on the OK button.
Contrast setup
The CONTRAST parameter allows to choose the photocopy contrast.
845 - ADVANCED FCT/COPY/CONTRAST
1Setup the desired level of contrast with the buttons
and , confirm by pressing the OK button.
2You can also directly setup the desired contrast
with the 
button, press several times on this button until the desired setup without using the Menu 845.
3 Quit this menu by pressing the 
button.
Brightness setup
The BRIGHTNESS parameter allows to lighten or darken your original document.
846 - ADVANCED FCT/COPY/LUMINOSITY
1Setup the desired brightness with the buttons and .
2Confirm your choice by pressing the OK button.
3 Quit this menu by pressing the 
button.
- 14 -
