26

●Random Input Selection Mode

• Unless a user changes channels, the last selected channel is used to continue transmission.
A change of channel by one user causes the channels of the other users connected to the WJ-NT104 to be switched to
that same channel. This means that the monitored picture may suddenly change to another.
• The image transfer rate is highest in this mode.
• This mode is the factory default setting.
LINK RCV XMT
OPERATE
Network Interface Unit WJ-NT104
1
1
1
1
PC
PC
PC
PC
WJ-NT104
CAMERA
CAMERA
CAMERA
CAMERA
LINK RCV XMT
OPERATE
Network Interface Unit WJ-NT104
1
2
3
4
PC
PC
PC
PC
WJ-NT104
CAMERA
CAMERA
CAMERA
CAMERA
●Multi Input Selection Mode
• This mode switches periodically between multiple channels at high speed so that transmission to two or more users
requesting different channels is possible. There is no sudden change to another camera picture.
• The image transfer rate is lowest in this mode.
■Operation Modes
The following three modes are available for controlling the input from the up to four cameras connected to the WJ-NT104.
¡Random Input Selection Mode
¡Multi Input Selection Mode
¡Fixed Input Selection Mode
To set up the mode, access the ADMINISTRATOR SETUP PAGE (see page 40) from the home page of the WJ-NT104.
To select a mode see MODE SETUP on page 41.