Panasonic WJ-NT104 operating instructions 0FOCUS, 1IRIS, 2AUTO PAN

qCAMERA SELECT (Left window panel)

To select a camera (camera 1 to 16) connected to the WJ-FS616 Video Multiplexer. The image of the select- ed camera is displayed in spot mode.

wPRESET SELECT (Left window panel)

To move the combination camera (option) connected to the WJ-FS616 to any of 8 preset positions.

eALARM LIST

Any image before or after alarm input can be temporar- ily stored in the internal memory of the WJ-NT104. For alarm display see ALARM LIST on page 37.

rCAMERA SELECT (Bottom window panel)

To select a camera (camera 1 to 16) connected to the WJ-FS616. Select a camera number, and then click [SET] to apply it. The image of the selected camera is displayed in spot mode.

tMULTISCREEN SELECT

Clicking this button repeatedly will switch the screen as

follows:

4 → 7 → 9 → 10 → 13 → 16→ 4 screen segments

yPRESET SELECT (Bottom window panel)

To move the combination camera (option) connected to the WJ-FS616 to any of 64 preset positions. Select a preset position number, and then click the [SET] button to move the camera to the position.

uALARM ALL RESET

To reset all alarms activated in the Video Multiplexer, and return it to normal condition.

iPAN/TILT

Clicking anywhere on the live image moves the con- nected combination camera (option) up and down, or to the right and left. The camera pan/tilt angle decreases as the point clicked moves closer to the image center. Clicking the image center will not move the camera. Zooming does not change the camera pan/tilt angle. Click the image repeatedly to move the camera to the desired position. You cannot pan or tilt the camera continuously by dragging on the live image.

oZOOM

The connected combination camera (option) can be zoomed by clicking the [TELE] or [WIDE] button under ZOOM.

Clicking the [TELE] or [WIDE] button will operate the camera in telescopic or wide-angle mode for a speci- fied time, after which the mode is released automatical- ly. These modes cannot be retained by keeping the [TELE] or [WIDE] button depressed. You need to click the [TELE] or [WIDE] button again.

!0FOCUS

The connected combination camera (option) can be focused by clicking the [FAR], [NEAR] or [AUTO] but- ton under FOCUS.

Clicking the [FAR] or [NEAR] button will operate the camera in focusing mode for a specified time, after which the mode is released automatically. Clicking the [AUTO] button will automatically focus the image on the screen. Focus control cannot be retained by keep- ing the [FAR] or [NEAR] button depressed. You need to click the [FAR] or [NEAR] button again.

!1IRIS

The connected combination camera (option) can be controlled to close or open the iris by clicking the [CLOSE] or [OPEN] button under IRIS.

Clicking the [OPEN] or [CLOSE] button will open or close the camera iris for a specified time, after which the operation is released automatically.

Clicking the [RESET] button on the screen will reset the iris of the displayed camera to the factory default setting. Iris control cannot be retained by keeping the [OPEN] or [CLOSE] button depressed. You need to click the [OPEN] or [CLOSE] button again.

!2AUTO PAN

The auto pan status of the connected combination camera (option) can be changed by clicking the [ON] or [OFF] button under AUTOPAN.

Note: Note: When LOCAL is selected in the camera setup menu, auto pan is released automatically after 1 minute. When REMOTE is selected, auto pan will not be released automatically.

!3Image Display

The image output from the MULTISCREEN OUT con- nector of the video multiplexer connected to the WJ- NT104 is displayed.

60