Panasonic WJ-NT104 operating instructions 0AUTOPAN, 1PRESET

uZOOM

The connected combination camera (option) can be zoomed by clicking the [TELE] or [WIDE] button under ZOOM.

Clicking the [TELE] or [WIDE] button will operate the camera in telescopic or wide-angle mode for a speci- fied time, after which the mode is released automatical- ly. These modes cannot be retained by keeping the [TELE] or [WIDE] button depressed. You need to click the [TELE] or [WIDE] button again.

iFOCUS

The connected combination camera (option) can be focused by clicking the [FAR], [NEAR] or [AUTO] but- ton under FOCUS.

Clicking the [FAR] or [NEAR] button will operate the camera in focusing mode for a specified time, after which the mode is released automatically. Clicking the [AUTO] button will automatically focus the video on the screen. Focus control cannot be retained by keeping the [FAR] or [NEAR] button depressed. You need to click the [FAR] or [NEAR] button again.

oIRIS

The connected combination camera (option) can be controlled to close or open the iris by clicking the [OPEN] or [CLOSE] button under IRIS. Clicking the

[OPEN] or [CLOSE] button will open or close the cam- era iris for a specified time, after which the operation is released automatically.

Clicking the [RESET] button on the screen will reset the iris of the displayed camera to the factory default setting. Iris control cannot be retained by keeping the [OPEN] or [CLOSE] button depressed. You need to click the [OPEN] or [CLOSE] button again.

!0AUTOPAN

The auto pan status of the connected combination camera (option) can be changed by clicking the [ON] or [OFF] button under AUTOPAN.

Note: When LOCAL is selected in the camera setup, AUTOPAN automatically stops after 1 minute. When REMOTE is selected in the camera setup, AUTOPAN will not stop automatically.

!1PRESET

To move the connected combination camera (option) to any of 64 preset positions. Select a preset position number, then press the [SET] button to move the cam- era to the position.

36