
1 Monitor images on a PC
[AUX] buttons*2
These buttons will be displayed only when “Terminal 3” of “Alarm” is set to “AUX output” on the setup menu. (→page 125)
•[Open] button: The letters “Open” on the button will turn green and the status of the AUX connector will be open.
•[Close] button: The letters “Close” on the button will turn green and the status of the AUX connector
will be closed.
[Rec. on SD] button*2
This button will be displayed only when “Manual” is selected for “Save trigger” on the setup menu. (→page 63)
Click this button to manually record images on the SD memory card. Refer to page 35 for descriptions of how to manually record images on the SD memory card.
[Log] button*1
[List] button will become available only when “On” is selected for “Save logs” on the setup menu.
(→page 79) When this button is clicked, the log list will be displayed and images saved on the SD memory card can be played. Refer to page 41 for further information about the log list and for how to play images on the SD memory card.
Images from multiple cameras can be displayed on a
[Zoom] buttons*2 (when the image type is Quad PTZ or Single PTZ)
An image selected on the “Control Image” can be zoomed.
•: Click this button to adjust the zoom ratio to the “Wide” side.
• : Click this button to set the zoom ratio to x1.0.
• : Click this button to adjust the zoom ratio to the “Tele” side.
[Fisheye Control] button
When the [Fisheye Control] button is clicked, the “Fisheye Control” window will be displayed on a newly opened window, and operations can be performed. (→page 12)
[Auto mode]*2
Select an operation from the
•Auto pan: Automatically pans.
Even when the camera is operated for zooming, the camera continues panning. (However, panning will stop when the zoom button (x1) is clicked.)
•Preset sequence: Automatically moves to the preset positions (→page 109) orderly (start from the lowest preset position number).
Note
•If auto pan is used when the camera is mounted on a wall, depending on the tilt position, it may appear that the range of auto pan is reduced and the camera is not panning. In this case, adjust the tilt position up or down.
Control pad/buttons*2
Zoom can be adjusted by
[Control Image] pull-down-menu
When the image type is Quad PTZ, select the screen number of the image to control its preset, zoom, control pad/button settings.
20
Operating Instructions